Not much done on the layout this weekend as the weather was so nice, so plenty of garden time, but I did manage to start the track laying on board two of the lower staging yard. I’ve almost finished laying the track for the Metra yard. The Freight yard will have to wait as I am short of a few turnouts, so need to get those ordered. That will be next week’s project (assuming I can get turnouts as stock has been scarce lately!). Hoping to get another video edited and published this week, so keep an eye out for […]
I’ve starting adding the two signals for the lower staging yard. The Metra yard does not really need one as that passenger service will be run automatically by Railroad & Co’s TrainController, but it’s nice to have anyway. I’m using SignaTrak’s SIGM20 signal controller for this as it has all the logic built in for automatic signals (as opposed to Digtrax’s SE8C which requires JMRI to provide the signal logic). These signals will protect movements up and down the helix, making sure there are no cornfield meets…as long as the engineers obey the signal indications! I will be adding another […]
Follow along as I continue the build of my N scale model railroad. In this episode I finish off with the track planning and show you the track I have laid, along with a limitation I have found with the AnyRail track planning software.
I have added a drawer underneath the lower staging yard to hold the Digitrax Command Station (DCS100) and it’s power supply, my RaspberryPi which runs JMRI , the Tam Valley Depot 5A Booster for the accessory power bus and the power strip for the BDL160 & DAC20 power supplies (with spare for others if needed). I got this idea from a few YouTube channels and thought it was a brilliant idea – provides a place for all the DCC equipment as well as making it easily acccessible by using a drawer.
It’s official…the wiring for the first lower staging yard board is finished!